Beiträge von tomgembus

Zitat von Cheesy

ok, really confusing... so I think you maybe have to go to a "Renault Garage", and try to solve with the CAN-Clip, what "edgieee" says...

one last idea - I would try to clear the error-memory, and then reset the "parking aid ECU"... you can do this with PyRen for example...

if you did not try that, yet...

otherwise I don't know anything else that could solve this problem... except only that BSW remains switched off...

I am sorry, of course it is not funny, if something is not working properly

Alles anzeigen

Vielen Dank für Ihren Rat, Cheesy . Leider gibt es in Indonesien keine Renault-Händler mehr..

Ich habe versucht, den Fehlerspeicher mit Pyren zu löschen, aber es hat nicht funktioniert, aber ich werde es noch einmal versuchen, vielleicht mit einer anderen ECU. .

Und ja, BSW und „Easy Parking“ werden nicht verwendet. Kleines Problem, aber ziemlich ärgerlich.. Ich liebe das Auto immer noch...

Zitat von Cheesy

Sorry, I also have no other idea... ? (

and I think perhaps the problem is in the "parking aid ECU", or any other component, and not the programming...

but let me know one more thing - came the error suddenly, or what happened before...? has it ever worked properly...?

yes, Cheesy , it worked fine before.. it happened as edgieee Said.. Parking sensors work perfectly..

Zitat von Cheesy

I searched online now, and I found your question at "github - cedricp/ddt4all"

"

my Koleos II had message "Trailer:Blind Spot Alert Off" when i turn on BSW on R-Link 2..It hasn't Trailer/Towbar or mount it..
Is there any menu in DDT4ALL to deactive auto trailer/towbar?
Maybe it caused by the load in my Koloes trunk before.. so it detected trailer..

"

So in this particular case, it may also be that we are looking for the problem with the wrong ECU...

Alles anzeigen

Yes Cheesy .. , I still have no idea where the trailer menu is..

satus general.png

Zitat von Cheesy

Hello

ok, I'm not sure, but I think I've seen this in the ECU "Aide au parking" somewhere in a screen... that was something with "trailer hook detection" or something like that...

parkassi3.jpg

should be there..

I've searched but haven't found it yet..

Hello again, Cheesy  Armin767 , is it possible to disable trailer mode with DDT4ALL? My car has detected a trailer, but there is none attached. Therefore, the blind spot warning is disabled.

Thank you very much for the answer

Zitat von Armin767

Hello

it would be nice if you just replace it and then you have the additional equipment.

In the Volkswagen Group, it was even common for some optional extras to be installed but not activated.

On my Tiguan I activated the cornering light via the software and without any problems.

But seat heating without appropriate seats is bad, the cables will probably even be lying down, so tomgembus could certainly even connect all switches. Only the control unit will be missing and so you can't unlock anything that isn't there.

Greetings Armin

Alles anzeigen

nice.. thanks for the answer Armin767 ..

Zitat von Cheesy

Hallo tomgembus,

nein, so einfach wird das nicht funktionieren... es muss auch die ganze Verkabelung, Relais, u. natürlich Heizmatten in den Sitzen und alles nötige vorhanden sein, und dann kann die Taste für Sitzheizung benutzt werden... da gibt es keine Programmierung mit ddt4all... und auch beim "Park-Assistent" und "Auto-Start/Stopp" muss die Verkabelung, Sensoren, und alles was dahinter ist, auch in der Hardware vorhanden sein, und das muss dann aber schon auch zusätzlich programmiert werden... dazu müssen aber natürlich auch die richtigen Steuergeräte verbaut sein...

viele Grüße

ich verstehe..danke Cheesy ..